C
HAPTER
21
| System Management Commands
Line
– 528 –
COMMAND MODE
Line Configuration
COMMAND USAGE
◆ If a login attempt is not detected within the timeout interval, the
connection is terminated for the session.
◆ This command applies to both the local console and Telnet connections.
◆ The timeout for Telnet cannot be disabled.
◆ Using the command without specifying a timeout restores the default
setting.
EXAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
disconnect This command terminates an SSH, Telnet, or console connection.
SYNTAX
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
COMMAND MODE
Privileged Exec
COMMAND USAGE
Specifying session identifier “0” will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.
EXAMPLE
Console#disconnect 1
Console#
RELATED COMMANDS
show ssh (618)
show users (507)
To Next Page
Loading...
Need help?
General