C
HAPTER
22
| SNMP Commands
– 559 –
EXAMPLE
Console#show snmp
SNMP Agent : Enabled
SNMP Traps :
Authentication : Enabled
Link-up-down : Enabled
SNMP Communities :
1. public, and the access level is read-only
2. private, and the access level is read/write
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP Logging: Disabled
Console#
snmp-server enable
traps
This command enables this device to send Simple Network Management
Protocol traps or informs (i.e., SNMP notifications). Use the no form to
disable SNMP notifications.
SYNTAX
[no] snmp-server enable traps [authentication | link-up-down]
authentication - Keyword to issue authentication failure
notifications.
link-up-down - Keyword to issue link-up or link-down notifications.
DEFAULT SETTING
Issue authentication and link-up-down traps.
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to configure
this device to send SNMP notifications, you must enter at least one
To Next Page
Loading...
Need help?
General