Edge-Core ES3510MA

C HAPTER 16 | IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 416 –
with a global unicast address. Both link-local and global unicast address
types can either be dynamically assigned (using the Configure Interface
page) or manually configured (using the Add IPv6 Address page).
CONFIGURING THE
IPV6 DEFAULT
GATEWAY
Use the IP > IPv6 Configuration (Configure Global) page to configure an
IPv6 default gateway for the switch.
CLI REFERENCES
◆ "ip default-gateway" on page 919
PARAMETERS
These parameters are displayed:
◆ Default Gateway – Sets the IPv6 address of the default next hop
router.
■
An IPv6 default gateway must be defined if the management station
is located in a different IPv6 segment.
■
An IPv6 default gateway can only be successfully set when a
network interface that directly connects to the gateway has been
configured on the switch.
WEB INTERFACE
To configure an IPv6 default gateway for the switch:
1. Click IP, IPv6 Configuration.
2. Select Configure Global from the Action list.
3. Enter the IPv6 default gateway.
4. Click Apply.
Figure 251: Configuring the IPv6 Default Gateway