– 911 –
40 DHCP COMMANDS
These commands are used to configure Dynamic Host Configuration
Protocol (DHCP) client functions.
DHCP CLIENT
Use the commands in this section to allow the switch’s VLAN interfaces to
dynamically acquire IP address information.
N
OTE
:
DHCPv6 stateful configuration of IP address prefixes is not
supported in the current software release. If the router advertisements
have the “other stateful configuration” flag set, the switch will attempt to
acquire other non-address configuration information (such as a default
gateway) from a DHCPv6 server.
Table 133: DHCP Commands
Command Group Function
DHCP Client Allows interfaces to dynamically acquire IP address information
Table 134: DHCP Client Commands
Command Function Mode
DHCP for IPv4
ip dhcp client class-id Specifies the DHCP client identifier for an interface IC
ip dhcp restart client Submits a BOOTP or DHCP client request PE
DHCP for IPv6
ipv6 dhcp restart client vlan Submits a DHCPv6 client request PE
show ipv6 dhcp duid Shows the DHCP Unique Identifier for this switch PE
show ipv6 dhcp vlan Shows DHCPv6 information for specified interface PE
To Next Page
Loading...
Need help?
General