C
HAPTER
38
| LLDP Commands
– 893 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv vlan-name
Console(config-if)#
lldp dot3-tlv link-agg This command configures an LLDP-enabled port to advertise link
aggregation capabilities. Use the no form to disable this feature.
SYNTAX
[no] lldp dot3-tlv link-agg
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
This option advertises link aggregation capabilities, aggregation status of
the link, and the 802.3 aggregated port identifier if this interface is
currently a link aggregation member.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv link-agg
Console(config-if)#
lldp dot3-tlv mac-
phy
This command configures an LLDP-enabled port to advertise its MAC and
physical layer capabilities. Use the no form to disable this feature.
SYNTAX
[no] lldp dot3-tlv mac-phy
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
This option advertises MAC/PHY configuration/status which includes
information about auto-negotiation support/capabilities, and operational
Multistation Access Unit (MAU) type.
To Next Page
Loading...
Need help?
General