C
HAPTER
35
| Class of Service Commands
Priority Commands (Layer 3 and 4)
– 829 –
show qos map trust-
mode
This command shows the QoS mapping mode.
SYNTAX
show qos map trust-mode interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
COMMAND MODE
Privileged Exec
EXAMPLE
The following shows that the trust mode is set to CoS:
Console#show qos map trust-mode interface ethernet 1/5
Information of Eth 1/5
COS Map mode: cos mode
Console#
To Next Page
Loading...
Need help?
General