Edge-Core ES3510MA - Spanning-Tree Loopback-Detection Release; Spanning-Tree Spanning-Disabled

C HAPTER 33 | Spanning Tree Commands
– 777 –
EXAMPLE
Console(config)#interface ethernet ethernet 1/5
Console(config-if)#spanning-tree edge-port
Console(config-if)#spanning-tree root-guard
Console(config-if)#
spanning-tree
spanning-disabled
This command disables the spanning tree algorithm for the specified
interface. Use the no form to re-enable the spanning tree algorithm for the
specified interface.
SYNTAX
[no] spanning-tree spanning-disabled
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
EXAMPLE
This example disables the spanning tree algorithm for port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree spanning-disabled
Console(config-if)#
spanning-tree
loopback-detection
release
This command manually releases a port placed in discarding state by
loopback-detection.
SYNTAX
spanning-tree loopback-detection release interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
COMMAND MODE
Privileged Exec
COMMAND USAGE
Use this command to release an interface from discarding state if loopback
detection release mode is set to “manual” by the spanning-tree loopback-
detection release-mode command and BPDU loopback occurs.