Edge-Core ES3510MA

C HAPTER 20 | General Commands
– 490 –
disable This command returns to Normal Exec mode from privileged mode. In
normal access mode, you can only display basic information on the switch's
configuration or Ethernet statistics. To gain access to all commands, you
must use the privileged mode. See "Understanding Command Modes" on
page 478.
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
COMMAND USAGE
The “>” character is appended to the end of the prompt to indicate that the
system is in normal access mode.
EXAMPLE
Console#disable
Console>
RELATED COMMANDS
enable (487)
reload (Privileged
Exec)
This command restarts the system.
N OTE : When the system is restarted, it will always run the Power-On Self-
Test. It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config command.
DEFAULT SETTING
None
COMMAND MODE
Privileged Exec
COMMAND USAGE
This command resets the entire system.
EXAMPLE
This example shows how to reset the switch:
Console#reload
Note: It takes around 100~120 seconds to finish system reboot.
Do you really want to reset the switch?