X-STREAM
5-16
Instruction Manual
HASAxE-IM-HS
05/2006
Emerson Process Management GmbH & Co. OHG
Control..
Adv. calibration..
5-4-2-3 Advanced Calibration Menu
5-4 Menu System - Control Menu
When this line is selected, pressing the key
cancels the ongoing calibration procedure
without any changes
When this line is selected, pressing the key
starts zero calibrations for all channels.
CANCEL calibration!
ZeroAll!
SpanAll!
ZeroSpanAll!
When this line is selected, pressing the key
starts span calibrations for all channels.
When this line is selected, pressing the key
starts zero and span calibrations for all channels.
Note!
For detailed descriptions of how to perform
calibrations
chapter 7 Maintenance.
Note!
This menu appears for dual channel as well
as for single channel instruments: In this case
the 2
nd
and 3
rd
line act like the separate zero /
span calibration menus while the 4
th
line
allows to start zero and span calibration by
pressing just one key.
Note!
This menu is available only if the parameter
"Valves" in the INSTALLED OPTIONS setup
menu is other than none
To Next Page
Loading...
