X-STREAM
5-44
Instruction Manual
HASAxE-IM-HS
05/2006
Emerson Process Management GmbH & Co. OHG
5-4-3-8 Save-Load Menu
If system is setup accordingly access level 3
code must be entered to access this menu.
Save-Load
CfgData>COMport!
COMport>CfgData..
Verify!
Pressing the  key while this line is selected
starts a configuration backup procedure. The
data is sent to the serial interface.
Pressing the  key while this line is selected
starts a configuration restore procedure: The
instrument now waits for data to be received
via the serial interface.
CAUTION!
This overwrites all ConfigData. Changes made
since last backup are lost!
Note!
A query screen appears to confirm starting the
procedure.
Use this line to start a "COMport>CfgData"
procedure for a online comparison of the
current ConfigData set with data received via
the serial interface.
The current configuration data is not over-
written! Incoming data is erased after being
compared to the RAM data.
5-4 Menu System - Safe-LoadMenu
1
st
menu page
Note 1!
All the following procedures require an
appropriate terminal software to be installed
on an external hardware (e.g. PC, connected
to the serial interface) to receive and save the
data.
Note 2!
A notification screen appears while ongoing
procedures, showing how to cancel.
Setup..
Save-Load..
To Next Page
Loading...
Need help?
General
