Section 6 — Standard Sound Parameters
2 ENSONIQ KT Musician’s Manual
To select a single voice for editing:
1. Press {EDIT_SOUND}.
2. Press the upper {0} button, then the lower {0} button to get to page 00.
You will see the EditVOICE/Voice Status page shown above. If the Selected Voice value (top
of the display) is not flashing, press the {<} button once.
3. Use the Data Entry Slider or the {VALUE} buttons to set “EditVOICE:VOICE1, 2, or 3”.
To select all voices for editing:
1. Press {EDIT_SOUND}.
2. Press the upper {0} button, then the lower {0} button to get to page 00.
You will see the EditVOICE/Voice Status page. If the Selected Voice value (top of the
display) is not flashing, press the {<} button once.
3. Use the Data Entry Slider or the {VALUE} buttons to set “EditVOICE:ALL”.
When “ALL” is selected, changes made to any of the programming parameters will affect all
voices playing within that sound. If you use the {VALUE} buttons to edit a parameter with
EditVOICE=ALL, the settings for each voice will change relative to one another, rather than
to the exact value displayed. Using the Data Entry Slider will set all voices the same value.
Voice Status Range: OFF, ON, or SOLO
These parameters are used to determine which voice(s) will play and/or be edited. These values
correspond to the three voices that make up a KT sound.
A voice is selected for editing by setting the EditVOICE parameter to that voice, then pressing the
{>} button to select the voice status value and setting it to either ON or SOLO. When the voice is
selected (EditVOICE:VOICE1-3), the corresponding Voice Status value will begin flashing. From
that point, any editing you do will affect that particular voice. If the voice you wish to edit is set
to “OFF,” you will be unable to edit any parameters for that voice, and the display will
momentarily show “Sorry current voice is muted.”
There are three status options that a voice can be set to on this page:
• OFF — The selected voice is muted, will not play, and cannot be selected.
• ON — The selected voice will play, and can be selected.
• SOLO — The selected voice will play and can be selected, and all other voices will be muted.
This is convenient for occasions when you’d like to hear how your edits are affecting a
particular voice.
☞ Remember: The Voice Status value that is flashing is the one that is selected for editing.
To Next Page
Loading...
Need help?
General
