Section 4 — Effects Parameters
4 ENSONIQ KT Musician’s Manual
WARM CHAMBER
WARM CHAMBER is a characteristically resonant chamber reverb. The FX1 and FX2 busses are
independently adjustable.
L
R
Reverb
FX1
FX2
Mix1
Mix2
Audio
Outputs
DRY
WARM CHAMBER Routing
The parameters available in this effects algorithm are:
Decay Time Range: 00 to 99
Sets the amount of time it takes for the reverberation to fade to a very low level (-60 dB) after the
input signal stops.
Diffusion Range: 00 to 99
Determines whether the early reflections will appear as a series of discrete echoes (lower values),
or will be more diffused (higher values).
Detune Rate Range: 00 to 99
Controls the rate of detuning in the reverb. Detuning creates a slight pitch shift, giving a more
natural sounding decay by breaking up resonant nodes.
Detune Depth Range: 00 to 99
Controls how much the pitch will change. Low values yield a resonant, metallic sound. Some
voices may require low values.
HF Damping Range: 00 to 99
Controls the high frequency decay of the reverberation. As natural reverb decays, some high
frequencies tend to get absorbed by the environment. Increasing the value of this parameter will
filter out increasing amounts of high frequency energy during the decay of the reverb.
HF Bandwidth Range: 00 to 99
The High Frequency Bandwidth parameter filters the signal going into the reverb, controlling the
amount of high frequencies that will pass into the effect. The higher the setting, the more high
frequencies will pass, resulting in an apparently brighter reverb.
Modulation Destinations
FX1-MIX FX2-MIX DECAY DAMPING
To Next Page
Loading...
Need help?
General
