Section 4 — Effect Parameters
ENSONIQ KT Musician’s Manual 11
FLANGER+REVERB
FLANGER+REVERB features two LFOs at different rates combined with a reverb. Assign a voice
to FX1 to get both flanger and reverb, or use FX2 for reverb only.
L
R
Reverb
Mix1
Mix2
Audio
Outputs
Flanger
FX1
FX2
DRY
FLANGER+REVERB Routing
Flange Rate Range: 00 to 99
Controls the rate of the modulation applied to the flange effect.
Flange Depth Range: 00 to 99
Controls the range of the high-to-low frequency sweep in the flanger effect.
Flange Center Range: 00 to 99
Sets the sweep mid-point of the flanger effect.
Feedback Range: -99 to +99
Controls the amount of feedback applied to the flanger. Positive or negative values will impart a
different tonality to the flange effect, either accenting the peaks or the notches.
Notch Depth Range: 00 to 99
Controls the depth of the peaks and notches produced by the flanger. This parameter should be
set to 99 for maximum effect.
Input Invert Range: OFF or ON
Inverts the input signal before combining it with the flanged signal. It creates peaks instead of
notches, for a different effect.
Rev
Decay Bias
See the description in the Dual EQ+Reverb algorithm.
Modulation Destinations
FX1-MIX FX2-MIX RATE DEPTH
CENTER FDBACK NOTCH DECAY
To Next Page
Loading...
Need help?
General
