Section 1 — Controls & Basic Functions
ENSONIQ KT Musician’s Manual 19
To Change a Parameter
Suppose you want to adjust the pitch of the current voice in the current sound. This is a pitch
parameter, so you first need to go to the Pitch page, then you would use the Data Entry Controls
to select and edit the values.
1. Press the {EDIT_SOUND} button.
2. Press the upper {1} button, then the lower {0} button. The display shows:
Oct=+0 Semi= +00 Fine= +00
The Oct (octave) parameter comes up in the display. This value segment of this parameter
will be flashing, telling you that it has been selected, and can be modified. If the Oct value is
not selected (flashing), press the lower {0} button until the Oct value is flashing.
3. To raise or lower the Oct (octave) parameter, press either of the {VALUE} buttons. The
display changes, showing the newly selected octave value.
Multiple Parameters
Some KT pages contain more than one editable parameter. When a page with multiple
parameters is displayed, there are two methods of moving between parameters:
The {CURSOR} buttons
({<} and {>})
These buttons scroll through each parameter shown on the currently
selected page, and then continue to the next or previous page.
The lower {0} to {9} buttons
Repeatedly pressing a lower {0} to {9} button scrolls through each
parameter shown on that page, and will not continue to the next or
previous page. When a lower {0} to {9} button is held for about one
second, the first parameter on that page will automatically be
selected.
To Next Page
Loading...
Need help?
General
