Section 1 — Controls & Basic Functions
ENSONIQ KT Musician’s Manual 17
Choosing Internal, ROM, and Card Sequences/Presets/Songs
In Select Sequence/Preset mode, the display shows the bank and page location, and the name of
the Sequence/Preset or Song:
Bank Location A Preset is selected Sequencer Location
l m n
iPSET00 Seq/Preset-00
i
Preset Name
There are two methods that can be used to choose between the four banks:
• The {BANK} button — Repeatedly pressing the {BANK} button will step through the various
banks. The bank location in the upper left corner of the display will change.
• Direct-Dialing — You can reach any of the banks directly by pressing the {BANK} button,
and while continuing to hold the {BANK} button down, press one of the lower {0} to {3}
buttons.
Select
Sound
1 2 3 4 5 60 7 9
8
Bank
i
r
a
b
: INT
: ROM
: CARD
: CARD
Bank Button
i:INT r:ROM a:CARD b:CARD
The lower {0} to {3} buttons are used to choose between i:INT, r:ROM, a:CARD and b:CARD
sequences/preset/songs. Note that if there is no card installed, or there is no sequencer data
on the card, the a:CARD and b:CARD banks will not be recognized.
The current Sounds bank and Seq/Preset bank are independent. Changing one does not change
the other.
The KT will default to the last selected i:INT sequence/preset/song location on power on.
To Next Page
Loading...
Need help?
General
