Section 9 — Preset/Track Parameters
ENSONIQ KT Musician’s Manual 9
You should consult the MIDI implementation chart of the MIDI device you will be using with the
KT to see which (if any) type of pressure it responds to and transmits. For best results, set the KT
Pressure parameter to match the type of pressure supported by the external MIDI device that will
send to or receive from the track you are setting.
Edit Track
page 7
Sustain Pedal
iPSET01 Trk01 - SustainPedal=ON
Sustain Pedal Range: OFF or ON
Allows you to determine whether each individual track will respond to sustain controller events.
The effect of all sustain events, whether from the KT sustain pedal (FtswR=SUSTAIN on
{SYSTEM"MIDI}, page {2}) or sustain commands received from MIDI (controller #64), is
controlled by this switch.
• ON — sustain events will affect all notes played within the active key range for this track.
• OFF — sustain events will have no effect on the notes played on this track.
For example, it may be useful to turn off sustain events on a track set up as a bass sound in a split
keyboard configuration. This allows you to play staccato bass lines on the lower part of the
keyboard, while playing chords on the upper part of the keyboard and using the sustain pedal.
The bass notes will not be affected by the sustain pedal (because the bass track sustain is set to
OFF) but the chords will sustain.
To Next Page
Loading...
Need help?
General
