ENSONIQ KT-88 Musician's Manual

Section 6 — Standard Sound Parameters
22 ENSONIQ KT Musician’s Manual
Filters Pages (40 - 44)
Each KT voice has two filters, Filter 1 and Filter 2, that are connected in series. The filter settings
determine which ranges of frequencies will be allowed to pass through to the output.
Edit Sound
page 40
Filter1/Filter2
Filter1= 2LoPass Filter2= 2HiPass
Filter1 Range: 2LoPass, 3LoPass
Determines whether Filter 1 will be a 2-pole or 3-pole low pass filter.
Filter2 Range: 2HiPass, 1HiPass, 2LoPass, 1LoPass
Filter 2 can be configured as a 2-pole or 1-pole high pass filter, or a 2-pole or 1-pole low pass
filter.
Note: These two parameters are “tied together” — changing the value of one will also
change the value of the other.
Edit Sound
page 41
FC1 Cutoff/Envelope2
FC1 Cutoff = 055 Envelope2 = +44
FC1 Cutoff Range: 000 to 127
Determines the initial, or manual, filter cutoff frequency. Filter 1 is always a low pass filter. A
setting of 127 lets all the original signal pass through the filter. Lower cutoff settings allow fewer
high frequencies through, somewhat like turning down the treble on a stereo.
Envelope2 Range: -99 to +99
Determines the amount or depth by which envelope 2 will affect the filter cutoff frequency.

ENSONIQ KT-88 Specifications

General

Brand	ENSONIQ
Model	KT-88
Category	Keyboard
Language	English