ENSONIQ KT-88 Musician's Manual

Section 10 — Understanding the Sequencer
ENSONIQ KT Musician’s Manual 25
3. Set the record parameter to “Record = MIXDOWN.”
4. Press the lower {4} button, and set the “Song Edit Tracks Displayed” parameter to “Song Edit
Tracks Displayed=SEQ.”
5. Press the {SEQUENCER/PRESET_TRACK} button of the sequence track that you want to mix
down. If you select Track 3, for example, the volume and pan changes you are about to
record will affect whatever is on Track 3 of each sequence throughout the song.
6. Press the {EDIT_TRACK} button, and press the lower {0} button, which contains the volume
level for the track, with the current track’s setting displayed (or select the Pan parameter to
record dynamic panning changes).
7. While holding down {RECORD}, press {PLAY}. The KT enters Overdub.
8. Use the Data Entry Slider or the {VALUE} buttons to mix the volume (or pan) of the selected
track. All changes you make will be recorded.
9. At the end of the song, or when you press {STOP"CONTINUE}, the Keep NEW/OLD page
appears. Here you can audition the changes before deciding whether to keep the new or the
original track.
10. To mix another track, press a different {SEQUENCER/PRESET_TRACK} button, select the
Volume or Pan parameters and then repeat the procedure.
To Record Mix or Pan Changes to a Song Track
1. Select a song containing song tracks you want to mix down.
2. Press {EDIT_SEQ/PRESET}, and select the Sequencer Control page by pressing the upper {1}
button, followed by the lower {1} button.
3. Set the record parameter to “Record = MIXDOWN.”
4. Press the lower {4} button, and set the “Song Edit Tracks Displayed” parameter to “Song Edit
Tracks Displayed=SONG.”
Note: With a song selected, you can toggle between Song tracks and Sequence tracks
by double-clicking any of the eight {SEQUENCER/PRESET_TRACK} buttons while in
Edit Seq/Preset mode. The track’s LED will flash when the sequence tracks are being
displayed, and remain solidly lit when song tracks are shown. Note also that song
tracks are always shown as 09-16, where sequence tracks are shown as 01-08.
5. Press any of the {SEQUENCER/PRESET_TRACK} buttons and select the song track that you
want to mix down. If you select Track 3, for example, the volume and pan changes you are
about to record will affect whatever is on Song Track 3 (listed as Track 11) throughout the
song.
6. Press the {EDIT_TRACK} button, and press the lower {0} button, which contains the volume
level for the track, with the current track’s setting displayed (or select the Pan parameter to
record dynamic panning changes).
7. While holding down {RECORD}, press {PLAY}. The KT enters Overdub.
8. Use the Data Entry Slider or the {VALUE} buttons to mix the volume (or pan) of the selected
track. All changes you make will be recorded.
9. At the end of the song, or when you press {STOP"CONTINUE}, the Keep NEW/OLD page
appears. Here you can audition the changes before deciding whether to keep the new or the
original track.
10. To mix another track, press a different {SEQUENCER/PRESET_TRACK} button, select the
Volume or Pan parameters and then repeat the procedure.

ENSONIQ KT-88 Specifications

General

Brand	ENSONIQ
Model	KT-88
Category	Keyboard
Language	English