Section 2 — System•MIDI Parameters
ENSONIQ KT Musician’s Manual 17
System•MIDI
page 8
SysEx/ID/Song Select
SysEx=ON ID=01 Song Select= OFF
SysEx Range: OFF or ON
This parameter determines if the KT can receive MIDI System Exclusive messages. When
SysEx=OFF, the KT does not receive any MIDI System Exclusive messages. The Sys-Ex messages
that are sent from the Storage pages can always be transmitted regardless of the setting of this
switch (refer to the Appendix for more information about the KT Sys-Ex implementation).
ID Range: 01 to 16
This allows remote MIDI devices to address the KT via incoming MIDI Sys-Ex without changing
the Base MIDI Channel number. Think of this parameter as a higher level of identification. This
is also used to identify Sys-Ex messages transmitted by the KT, and is useful if you have more
than one KT in a MIDI system.
Song Select Range: OFF or ON
This determines if the KT will transmit and receive MIDI Song Select messages. When Song
Select=OFF, the KT will ignore incoming MIDI Song Select messages, and the KT will not
transmit MIDI Song Select messages when sequences and songs are selected. When Song
Select=ON, incoming MIDI Song Selects will select the corresponding KT sequence/song
locations, and selecting KT sequences and songs will cause the KT to transmit MIDI Song Select
messages.
MIDI Song Selects # 00-99 will select KT Sequence/Song locations # 00-99. Conversely, selecting
Sequence/Song locations # 00-99 will cause the KT to transmit MIDI Song Selects # 00-99.
To Next Page
Loading...
Need help?
General
