ENSONIQ KT-88 Musician's Manual

Section 9 — Preset/Track Parameters
2 ENSONIQ KT Musician’s Manual
Edit Track
page 1
Output
iPSET01 Trk01 - Output=CONTRL-
FX
Output Range: DRY, FX1, FX2, VOICE, or CONTRL-FX
Normally, different voices in a sound are assigned to one of the three different busses, as set in
the sound’s Output page ({EDIT_SOUND} upper {7}, lower {2}). On this page, you can override
the normal effects routing of the sound for each track. This may be useful when two sounds are
split or layered in a performance preset, and the effect is not appropriate for both.
L
R
Effect 2
Mix1
Mix2
Audio
Outputs
Effect 1b
FX1
FX2
DRY
Effect 1a
The available settings are:
• DRY forces all voices to the DRY bus
• FX1 forces all voices to FX1
• FX2 forces all voices to FX2
• VOICE uses normal voice routing as programmed in each sound.
• CONTRL-FX uses normal voice routing as programmed in each sound, and routes controller
information from this track to the effect. This is the default setting when a new
track is defined and/or when the Replace w/FX function is used to install a
sound and its effect. This ensures that any pre-programmed effect modulation
in a sound will still function. See Section 3 — Understanding Effects for more
information.

ENSONIQ KT-88 Specifications

General

Brand	ENSONIQ
Model	KT-88
Category	Keyboard
Language	English