ENSONIQ KT-88 Musician's Manual

Section 4 — Effects Parameters
6 ENSONIQ KT Musician’s Manual
EQ-CHORUS+REVERB
This effect combines a four voice chorus with the standard reverb. Assign a voice to FX1 to get
both chorus and reverb, or use FX2 for reverb only.
L
R
Reverb
Mix1
Mix2
Audio
Outputs
EQ Chorus
FX1
FX2
DRY
EQ-CHORUS+REVERB Routing
FX1 F Gain
BW Out
See the description in the Dual EQ+Reverb algorithm.
Chorus Rate Range: 00 to 99
Controls the four rates of the modulation applied to the delay time of the chorus.
Chorus Depth Range: 00 to 99
Controls the amount of modulation. A Chorus Depth of 00 bypasses the chorus.
Chorus Center Range: 00 to 99
Controls the four delay times within the chorus. Adjusting this parameter will change the tonal
character of the chorus.
Feedback Range: -98 to +98
Controls the amount of feedback applied to the chorus. Positive settings are in-phase, whereas
negative values are out-of-phase, and impart a different tonality to the chorus.
Chorus Level Range: 00 to 99
Controls the Dry/Wet mix of the chorus.
Rev Decay Bias
See the description in the Dual EQ+Reverb algorithm.
Modulation Destinations
FX1-MIX FX2-MIX EQ FREQ EQ GAIN
EQ BW EQ OUT CH RATE CH DEPT
CH CNTR CH FDBK CH LEVL DECAY

ENSONIQ KT-88 Specifications

General

Brand	ENSONIQ
Model	KT-88
Category	Keyboard
Language	English