Section 6 — Standard Sound Parameters
6 ENSONIQ KT Musician’s Manual
Mod Source Range: Various
Here you can choose which of the modulators will be used to modulate the Start Index. When
Mod=<OFF> and the Mod Amount is +000 or lower, the wave always starts playing from the
Start Index. If Mod=<OFF> and the Mod Amount is +001 or higher, the wave will always start
playing from the beginning, and ignore the Start Index.
When Wave=TRANSWAVE on the previous page, the Mod Source parameter chooses which of
the 15 modulators will control the movement of the sound. Any of the modulators can be
selected.
Mod Amount Range: -127 to +127
Determines how much the selected modulation source (above) will affect the wave: i.e. how far
away from the start point the sound will move. This parameter acts as the Start Index threshold:
With Mod Amounts set to +001 or higher, if the modulator output exceeds the Mod Amount, the
wave plays from the Start Index. With Mod Amounts set to +001 or higher, if the modulator
output is lower than the Mod Amount, the wave plays from the beginning. Negative mod
amounts produce the opposite effect. If the mod amount is set to +000, the sound will remain
static, always playing from the Start Index.
When Wave=TRANSWAVE on the previous page, the Mod Amount parameter determines how
much the selected modulator (above) will affect the wave; i.e. how far away from the start point
the sound will move. If Mod Amount is set to +000, the sound will remain static. Positive
amounts will modulate the sound forward (toward the end of the wave); negative modulation
amounts will move the sound back toward the beginning.
Edit Sound
page 04
Sample Shift/Mode
Sample Shift=+00
Mode=SHIFT ALL
Sample Shift Range: -60 to +60
Changes keyboard split points on multi-sampled waves in two ways, according to the Mode
parameter. This has the effect of setting the multi-samples to ranges you wouldn’t otherwise
hear (allowing aliasing in some cases), creating completely different colorations. A setting of +00
is the setting for normal multi-sample playback.
Mode Range: SHIFT ALL or STRETCH ONE
This parameter determines how the multi-sampled waves will shift.
• When Mode=SHIFT ALL, all multi-sample split points will be shifted up or down the
keyboard by the number of semitones specified by the Sample Shift parameter. This is the
setting for normal multi-sample playback.
• When Mode=STRETCH ONE, the Sample Shift value selects a key, relative to C4 (i.e.,
+02=D4), whose sample will be played on all keys below it, overriding the normal multi-
sample key map. Keys above the selected key will play their multi-samples as normal. The
same key’s sample will be stretched regardless of the Pitch page 10 Oct/Semi settings.
To Next Page
Loading...
Need help?
General
