Section 10 — Understanding the Sequencer
10 ENSONIQ KT Musician’s Manual
Erasing All Sequencer Memory
When you want to erase all sequences and songs in the currently selected sequencer bank, first
make sure you have saved any important data to a storage card or to a remote MIDI device using
MIDI system exclusive, then:
1. If not currently in Edit Sequence/Preset mode, press the {EDIT_SEQ/PRESET} button. The
LED in the button will light.
2. Select the Sequencer Control pages by pressing the upper {1} button.
3. Press the lower {7} button. The display shows:
Press ENTER to Erase Seq Memory
4. Press {ENTER}. The KT display shows:
Erase Seq Memory in Bank xxxxxx ?
This read-only page displays the selected bank to be erased.
5. Press the {YES} button. The KT erases all presets, sequences, and songs from the selected
sequence/preset bank. This will not erase any sounds used by the sequencer. After the
memory is erased, there will be one blank sequence and one blank song in locations 00 and 70
respectively (there is always one song and one sequence in memory).
• Note that when a ROM Sequence/Preset/Song is selected, this command cannot be
performed, and the display will momentarily show “Cannot edit ROM!”
To Next Page
Loading...
Need help?
General
