Section 6 — Standard Sound Parameters
ENSONIQ KT Musician’s Manual 23
Edit Sound
page 42
FC1 Keyboard/Mod
Filter Cutoff
m
FC1 Keyboard=+25 Mod=VEL * +29
i i
Mod Source Mod Amount
FC1 Keyboard Range: -99 to +99
Sets the amount by which the location of a note on a keyboard will modulate the filter cutoff
frequency (keyboard filter tracking). The scaling effect of this parameter is based on a 76-note
keyboard, with a center break-point of F4+. To have the filter track the keyboard exactly, set FC1
Keyboard=+50.
Mod Range: Various
Selects the source of modulation for the filter cutoff frequency from among the 15 available
modulators.
Mod Amount Range: -99 to +99
Determines the amount that the modulation source will affect the filter cutoff frequency.
Edit Sound
page 43
FC2 Cutoff/Envelope2
FC2 Cutoff Range: 000 to 127
Determines the initial, or manual, filter cutoff frequency. When Filter 2 is a low pass filter, it will
behave just like Filter 1. When Filter 2 is a high pass filter, a setting of 000 lets all the original
signal pass through. Higher cutoff settings on a high pass filter allow fewer low frequencies
through, somewhat like turning the bass down on a stereo system.
Envelope2 Range: -99 to +99
Determines the amount that Envelope 2 will affect the filter cutoff frequency.
Edit Sound
page 44
FC2 Keyboard/FC1 Mod➡FC2
FC2 Keyboard Range: -99 to +99
Sets the amount that the location of a note on a keyboard will modulate the filter cutoff frequency
(keyboard filter tracking). The scaling effect of this parameter is based on a 76-note keyboard,
with a center break-point of F4+. To have the filter track the keyboard exactly, set FC2
Keyboard=+50.
FC1 Mod➡FC2 Range: OFF or ON
Allows the modulator assigned to FC1 to also modulate FC2. FC2 has no modulation source of
its own. Enabling this parameter is the only way to apply modulation to FC2. When “FC1
Mod➡FC2= ON” the modulation source for FC1 and its modulation amount will be applied to
FC2.
To Next Page
Loading...
Need help?
General
