Section 8 — Understanding Presets
ENSONIQ KT Musician’s Manual 11
Using the Layer Lock Feature
Normally, when the {EDIT_TRACK} button is pressed, the KT enters Edit Sequence/Preset
mode. So, the last track selected or layered will be selected for parameter editing, and only one
track will be audible at a time. Layering of tracks is not normally available in Edit
Sequence/Preset mode. By using the Layer Lock function, the current combination of selected
and layered tracks can be dynamically “Locked” to allow Track Performance parameter editing
while tracks are layered. This allows you to edit the Performance Parameters for one track, while
still being able to play the full combination of multiple layered tracks, making it possible to adjust
each track’s Performance Parameters relative to the other tracks in the layer combination.
To “Lock” a Track Layer combination:
1. Press {SELECT_SEQ/PRESET}.
2. Press a {SEQUENCER/PRESET_TRACK} button and layer any combination of tracks, by
double-clicking their {SEQUENCER/PRESET_TRACK} buttons.
3. While holding down the {SELECT_SEQ/PRESET} button, press the {EDIT_TRACK} button.
Both the {SELECT_SEQ/PRESET} and {EDIT_TRACK} LEDs will light and the KT will now
be in “Layer Lock” Edit Track mode. All Edit Track Performance Parameter pages are
available as usual: from either successive presses of the {EDIT_TRACK} button, pressing the
{CURSOR} buttons, or by “direct dialing” with the lower {0} to {9} buttons.
4. Pressing a {SEQUENCER/PRESET_TRACK} button will not change the combination of
layered tracks, but instead will select that track for Performance Parameter editing.
5. To exit “Layer Lock” Edit Track mode, press any mode button.
To Next Page
Loading...
Need help?
General
