Section 6 — Standard Sound Parameters
ENSONIQ KT Musician’s Manual 1
Section 6 — Standard Sound Parameters
This section covers the parameters that can be edited independently for each voice within a
Standard Sound. For a general overview of the concepts involved, refer to the previous section.
Edit (Standard) Sound Mode
Whenever you want to do any editing to a Standard Sound, you must first place the KT into Edit
(Standard) Sound mode. Once in Edit (Standard) Sound mode, you can modify parameters of a
Standard Sound to better suit your needs or create a completely new sound.
To access the following parameters, first select a Standard Sound, and then press the
{EDIT_SOUND} button to enter Edit Sound mode. In Edit Sound mode, the upper {0} to {9}
buttons are used to access the groups of pages relating to sound editing, and the lower {0} to {9}
buttons are used to select the pages within that group. This combination of upper and lower
buttons is called the page number. Each page in Edit Sound mode has a two digit page number.
Store
Sound Data
Env 1 LFO FiltersWave
Pitch Env 2 Env 3 Output Effects
1 2 3 4 5 60 7 98
Wave Pages (00 - 05)
Each KT voice will play one of the 211 waves in its memory. These waves are the “raw material”
from which KT sounds are crafted. In the Wave pages you can choose which wave the currently
selected voice will play, and modify various playback parameters of the wave.
Edit Sound
page 00
EditVOICE/Voice Status
Selected Voice
m
EditVOICE:VOICE1 ON ON ON
p i j
Voice Status Values
EditVOICE Range: VOICE1-3 or ALL
This parameter has three functions; to select whether to edit one voice or all voices within a
sound; to select which voice will be edited (if one voice is selected); and to determine the
playback status of that voice.
To Next Page
Loading...
Need help?
General
