Section 10 — Understanding the Sequencer
ENSONIQ KT Musician’s Manual 5
Sequencer Status
On many sequencer pages the upper right-hand corner of the display indicates the Sequencer
Status. The sequencer is always in one of the following states:
STOP
Sequencer at rest.
PLAY
Playing current sequence (sequence selected).
SNGS
Song Stop: sequencer at rest with a song selected.
SNGP
Song Play: playing current song.
REC
Recording on current track, first pass.
ODUB
Overdub: re-recording current track.
play
Countoff playing before going into Play, Record or Overdub.
rec
Record Standby: waiting for you to play before going into Record (first track only).
odub
“Overdub” Standby: waiting for you to play before going into Overdub.
mrec
MIDI sync Record Standby: same as Record Standby except that the sequencer
is synced to external MIDI clocks (CLOCK=MIDI on the Control page) and is
waiting for MIDI clocks before going into Record.
AUDP
Audition Play. This state is entered automatically from Record when the end of
the sequence is reached (assuming LOOP=ON). After leaving Record and
entering Audition Play, the sequence will continue to play in this state, with the
newly recorded track, until you press the {STOP"CONTINUE} or {SAVE} buttons.
The Display will then show “Press ENTER to keep NEW track.”
AUDS
Audition Stop is entered when you stop the sequencer from the Audition Play
state. To exit Audition Stop and return to the normal stop state, you must first
instruct the KT to KEEP either the NEW or the original OLD track (see KEEP
NEW/OLD screen later in this section).
To Next Page
Loading...
Need help?
General
