Section 4 — Effect Parameters
ENSONIQ KT Musician’s Manual 5
8-VOICE CHORUS
This is a complex stereo chorus that uses eight different delays and separately randomized LFOs
to produce pitch and amplitude modulation.
L
R
Chorus
FX1
FX2
Mix1
Mix2
Audio
Outputs
DRY
8-VOICE CHORUS Routing
Chorus Rate Range: 00 to 99
Controls the rate of pitch modulation applied to the delays.
Chorus Depth Range: 00 to 99
Controls the excursion of modulation. Since the rate is usually very slow, then the depth is
usually very large.
Chorus Center Range: 00 to 99
Controls the nominal delay time of the chorus about which the delay modulation occurs.
Adjusting this parameter will change the tonal character of the chorus.
Feedback Range: -99 to +99
Controls the amount of feedback applied to the chorus. Positive settings are in-phase, negative
values are out-of-phase, and impart a different tonality to the chorus.
Modulation Destinations
FX1-MIX FX2-MIX RATE DEPTH
CENTER FDBACK