ENSONIQ KT-88 Musician's Manual

Section 4 — Effects Parameters
12 ENSONIQ KT Musician’s Manual
PHASER+REVERB
A 12-pole phase shifter with reverb. Assign a voice to FX1 to get both phaser and reverb, or use
FX2 for reverb only.
L
R
Reverb
Mix1
Mix2
Audio
Outputs
Phaser
FX1
FX2
DRY
PHASER+REVERB Routing
Phaser Rate Range: 00 to 99
Controls the rate of the modulation applied to the phaser.
Phaser Depth Range: 00 to 99
Controls the amount of modulation applied to the phaser.
Phaser Center Range: 00 to 99
This parameter controls the mid-point of the phaser.
Feedback Range: -99 to +99
Controls the amount of feedback applied to the phaser. Positive or negative values will impart a
different tonality to the phaser effect, either accenting the peaks or the notches.
Notch Depth Range: 00 to 99
Controls the depth of the peaks and notches produced by the phaser. This parameter should
normally be set to 99.
Input Invert Range: OFF or ON
Inverts the input signal before combining it with the phase-shifted version. It creates peaks
instead of notches, for a different effect.
Rev
Decay Bias
See the description in the Dual EQ+Reverb algorithm.
Modulation Destinations
FX1-MIX FX2-MIX RATE DEPTH
CENTER FDBACK NOTCH DECAY

ENSONIQ KT-88 Specifications

General

Brand	ENSONIQ
Model	KT-88
Category	Keyboard
Language	English