Section 4 — Effects Parameters
14 ENSONIQ KT Musician’s Manual
Mix Range: 00 to 99
Controls how much of the amplifier distortion is mixed with the clean signal (there is an internal
clean path in parallel with the distortion). To eliminate distortion, set this parameter to 00.
Rev
Decay Bias
See the description in the Dual EQ+Reverb algorithm.
Modulate Speed by
This special modulation feature allows you to select a modulator and define what type of
modulation you want to use to affect the rotor speed. The two modulation modes are:
• TOGGLE — The modulation source toggles the rotor speed between the Speed Min setting
and the Speed Max setting. Every time the modulation source moves from zero in a positive
direction, the rotating speaker effect changes speeds from slow to fast or fast to slow. To
reverse the polarity of the switch, set Speed Min faster than Speed Max. Try this setting with
the Sustain pedal.
• CONTIN — The modulation source continuously switches between the Speed Min setting and
the Speed Max setting, based on the mod source position and/or movement. Try this setting
with the Mod Wheel — you’ll hear the rotary speaker change speed based on the position of
the wheel (and the Speed Min and Max settings).
With both types of modulation, the rotary speaker always takes the Inertia time to get to the Rotor
Speed MIN and MAX settings.
To Next Page
Loading...
Need help?
General
