Section 4 — Effects Parameters
16 ENSONIQ KT Musician’s Manual
LoPass Cutoff Range: 00 to 99
Filters out high frequencies after the distortion signal path. The lower the value, the fewer high
frequencies pass through.
Reverb to Cmprss Feedback Range: -99 to +99
Controls the amount of signal applied from the output of the reverb back into the input of the
compressor. The sign of the value determines the polarity of the feedback.
Note: Since the feedback level is taken from the FX1 bus, if FX1 is set to 00 or a low
value, feedback will have little or no consequence. Also, it is important to note that
since the signal is being taken from the reverb, which is also fed by the FX2 bus, voices
sent to the FX2 bus will enter the feedback loop with the FX1 signals.
Decay Time Range: 00 to 99
Controls the amount of time it takes for the reverberation to decay to a very low level (-60dB)
after the input signal stops.
HF Damping Range: 00 to 99
The High Frequency Damping parameter controls the high frequency decay of the reverberation.
As natural reverb decays, some high frequencies tend to get absorbed by the environment.
Increasing the value of this parameter will filter out increasing amounts of high frequency
energy.
Modulation Destinations
FX1-MIX FX2-MIX FDBACK DECAY
DAMPING
To Next Page
Loading...
Need help?
General
