308 Using the Control Panel
Using the Fax Settings menu
This function is used to cancel the fax transmission job stored in
the memory.
1. Make sure that the product is in Fax mode. If not, press the
Fax button to enter the Fax mode.
2. Press the Advanced/Menu button.
3. Press the d Down button to select Fax Job Information, and
then press the r Right button.
4. Press the d Down button to select Fax Transmission Job,
and then press the r Right button.
The FAX Transmission Job list is displayed.
Note:
To cancel the receiving fax job stored in the memory, press the u Up
or d Down button several times until FAX Reception Job is
selected and press the r Right button. Then select the incoming fax
you want to cancel from the FAX Reception Job list.
5. Press the u Up or d Down button to select the fax job you
want to cancel, and then press the Reset button.
6. Press the u Up or d Down button to select Yes for
confirmation, and then press the r Right button
To Next Page
Loading...
Need help?
General
