Using the Control Panel 315
9
9
9
9
9
9
9
9
9
9
9
9
Paper Set tttt sssss
The paper loaded in the specified paper source (tttt) does not
match the required paper size (sssss). Replace the loaded paper
with the correct size paper and press the x B&W Start or x Color
Start button to resume printing, or press the y Cancel button to
cancel the print job.
If you press the x B&W Start or x Color Start button without
replacing the paper, the product will print on the loaded paper
even though it does not match the required size.
Photoconductor Trouble
A read/write error has occurred for the photoconductor unit.
Remove the photoconductor unit and reinsert it. If that fails to
clear the error, replace the photoconductor unit. To install the
photoconductor unit. See “Photoconductor Unit” on page 342.
Please Wait
The toner cartridge to be replaced is moving to the replacement
position in the product.
Print Overrun
The required time to process the print data exceeded the print
engine speed because the current page is too complex. Press the
x B&W Start or x Color Start button to resume printing, or press
the y Cancel button to cancel the print job. If this message
appears again, select Avoid Page Error on the printer driver.
If you continue to receive this message when printing a particular
page, try simplifying the page by limiting the number of graphics
or reducing the number and size of fonts.
You can also add more memory to the product as described in
“Memory Module” on page 331.
To Next Page
Loading...
Need help?
General
