The setting method selection screen appears.
7. Select Advanced.
Select a connection method from the following
❏ “Ethernet Cable” on page 64
❏ “WPS-PIN” on page 70
❏ “WPS-PBC” on page 71
❏ “Operator Panel” on page 73
❏ “EpsonNet Config” on page 74
Ethernet Cable
1. Select Ethernet Cable, and then click Next.
2. Follow the on-screen instructions, and then click Next.
The Printer Setup Utility screen appears.
3. Select the printer to be configured in the Select Printer screen, and then click Next.
AL-MX200 Series User’s Guide
Printer Connection and Software Installation 64
To Next Page
Loading...
