M2-20 031914
Upper Infeed #1, #2, #4: The Upper
Infeed screen allows you to test the
operation of the Gripper Drive
Assembly. (Illustration 32)
Home: Homes the Gripper.
Move To ... : Enter the “Position” in
the keypad and touch “enter” The
Gripper will travel to the position
setting.
Homing Torque Override:
Increases the Homing Torque
setting, to assist in overcoming a
mechanical bind.
Stop: Stops Conveyor movement.
EStop: Stops Conveyor movement.
Reset Fault: Resets Faults.
ILLUSTRATION 32
HOME
MOVE TO ...
HOMING
TORQUE
OVERRIDE
STOP
ESTOP
RESET
FAULT
To Next Page
Loading...