STEP 6 INSTALL THE GRIPPERS
1. Slide the Grippers onto the mounting
blocks. (Illustration 32)
2. Center the Grippers on the mounting
blocks and tighten the retaining bolts
with a 13 mm “T-handle” wrench.
(Illustration 34)
3. Feed the Gripper airlines up through
the guide rings and connect them to the
grippers. (Illustration 33) There is a
“male” and “female” connector on each
set of airlines and cannot be connected
incorrectly. (Illustration 34)
5-10 031914
ILLUSTRATION 33
FEMALE
CONNECTOR
MALE
CONNECTOR
RETAINING
BOLT
GUIDE RINGS
GUIDE RINGS
ILLUSTRATION 32
ILLUSTRATION 31
SLIDE
GRIPPER
MOUNTING
BLOCKS
To Next Page
Loading...