FujiFilm CR Console - 1.1 For Safe Operation

CR Console Operation Manual
1 - 2 2010. 10 897N0519K
1.1 For Safe Operation
This chapter lists the precautions required to use the CR Console safely. Before starting use, read this
chapter very carefully and understand its operations thoroughly first.
1.1.1 Warnings and Cautions Included in this Operation Manual
Safety precautions described in this manual include “WARNING ( WARNING)” and
“CAUTION (
CAUTION)”, which are explained as follows.
WARNING
Indicates hazardous situations which may lead to serious injuries or even death if the precaution is
not or could not be followed.
CAUTION
Indicates hazardous situations which may lead to mild or medium injuries if the precaution is not or
could not be followed. Precautions against accidents causing only physical damages.
NOTE
Gives procedures requiring special attention, instructions which must be followed, supplementary
explanations, etc.
WARNING
This system supplies high voltage to the inside of unit, etc. The following instructions must be
carefully followed to prevent an electrical shock.
• No one other than service engineers should open the unit cover. Do not touch the high voltage
portion of the above-mentioned parts with your hand, or you may get an electric shock.
WARNING
The supply voltage of the units comprising this system is AC100V to 120V or AC200V to 240V.
The instructions below must be followed to prevent an electrical shock.
• Install the unit where no water may subject the units.
• Check that the ground of each unit has been perfectly connected.
• Check that all the cables have been properly and perfectly connected.
CAUTION
In extended uses of the unit, set aside 10 to 15 minutes after every hour to rest your eyes and hands.
• For image reading purposes, use an image display monitor suited for X-ray imaging diagnosis.
The image display monitor making part of this system is not suited for X-ray imaging diagnosis.
CAUTION
As the CR Console is not supposed to be operated continuously all day long, turn off the personal
computer once a day by performing the shutdown operation.
NOTE
The contents (objects) of the operation screens described in this manual may be changed/added/deleted
without any prior notice because of the software version upgrade.