CR Console Operation Manual
2011. 06 897N0519M 3 - 73
3.8 Image Delivery
Read images are delivered automatically. Conditions determined in the “Auto-delivery setting” at
Property Setting of User Utility are applied. For details, refer to
[Chapter 4 PROPERTY
SETTING / CR Console OPERATION MANUAL - THE USER UTILITY OPERATIONS]
.
Depending on the setting made at the time of installation, a character string (such as a hospital ID)
can be added before and after a study number and patient ID when delivering an image. Images can
also be output to each destination by specifying the “Photometric Interpretation” setting
(Monochrome1 or Monochrome2) in DICOM tag information. To make use of these functions,
contact our official dealer or local representative.
NOTES
Precautions when a multiple number of devices are specified as the target destinations
• Do as follows when re-delivering an image (that has been delivered once to a multiple number of
devices at the same time from the CR Console) after subjecting it to image edit processing (QA).
• If settings of the destination targeted for image delivery are to be changed at time of re-delivery,
settings must be determined so that such image is delivered to all originally specified destinations
to which it was actually delivered. Otherwise, a mismatch may result in the relative
correspondence between images from device to device.
Other precautions
• Both of the film and flip markers may be displayed, when an image with those markers set
is delivered. When applying the flip marker, set the film marker not to be displayed on the
image. For change of the setting, consult our official dealer or local representative.
• If the flip marker is set outside the trimming frame by changing the frame position, the image is
delivered without the flip marker embedded.
• Be sure to check the image before delivering it.
(1) Auto-delivery after QA completion
At the time when image editing (QA) is completed after image reading, the image will be delivered
automatically (including film output).
Images cannot be delivered by the user operation. (Image-delivery marks and delivery operation
icons are not displayed.)
(2) Distributes images automatically to all attributes whenever an image is read
When the image reading is completed, the image will be auto-distributed (including the film output).
For the images to which delivery processing has been started, the image-delivery mark will be
displayed.
Note, however, that the study of which delivery is executed with this setting cannot select “Exposure
finish” (Finish exposure only) at the time of study completion.
(3) Distributes images automatically only to Print attribute whenever an image is read
When the image reading is completed, the image will be auto-distributed onto film. In this case, other
image delivery processing excepting film output will be executed after the exposure terminating
operation is done at the Study Execution Screen. For the image to which delivery processing has
been started, the image-delivery mark will be displayed.
When
is selected in advance, the auto-delivery of the image to be read can be suspended
temporarily (
is displayed). This icon is used to deliver the image after it is confirmed.
To release temporary suspension, select
.
If exposure processing is completed after reading all image exposure menus and then selecting
, the temporary suspension is automatically released, and the images will be delivered.
Note that when the study is completed while the IP registered and exposure menu image remaining
unread, the study will be handled as interrupted and stacked to the “Local WL” list. The images are
thus left undelivered.
To Next Page