EasyManua.ls Logo

Fujitsu M10-4 - Chapter 6 Restoring The System; Restoring the Chassis; Installing the Power Cord

Fujitsu M10-4
342 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter
6
Restoring
the
System
This
chapter
describes
the
procedures
required
to
restore
the
system
after
FRU
maintenance.
See
this
chapter,
as
required,
when
performing
maintenance
on
each
FRU
described
in
Chapter
8
onward.
■
Restoring
the
Chassis
■
Incorporation
of
the
SPARC
M10-4S
chassis
(possible
only
in
a
system
with
a
building
block
configuration)
■
Incorporating
a
Chassis
and
I/O
Device
into
a
Physical
Partition
■
Powering
On
the
Physical
Partition
Requiring
Maintenance
■
Starting
the
Entire
System
6.1 Restoring
the
Chassis
This
section
describes
operations
required
to
restore
the
chassis.
6.1.1 Installing
the
power
cord
If
the
power
cord
of
the
SPARC
M10-4/M10-4S
was
removed
to
perform
the
maintenance
work,
connect
the
power
cord
and
then
attach
the
cable
clamp
to
the
power
cord.
1.
Connect
the
power
cord
to
the
PSU
backplane
unit.
87

Table of Contents

Related product manuals