Fujitsu M10-4 - Confirming the FRU Information and Resource Information

#

ldm

-V
Logical

Domains

Manager

(v

3.1
)

*

Version

of

Oracle

VM

Server

for

SPARC

Hypervisor

control

protocol

v

1.9

Using

Hypervisor

MD

v

1.3
XSCF>

version

-c

xcp
Table 4-2
Commands for checking FRU information and resource information
Command Description
showstatus Displays the FRU status. Out of the FRUs in the system
configuration, this command displays information on a faulty or
degraded unit or FRU.
showboards Displays information on a physical system board (PSB). Displays
information on a physical system board that belongs to the
specified physical partition and information on all the
physical
system boards that are mounted.
showpcl Displays the configuration information for a physical partition
(hardware resource information).
showfru Displays the setting information for a device.
To check the Oracle VM Server for SPARC version, execute the ldm(1M) command.
Confirming the firmware configuration
Use XSCF shell commands to check the firmware configuration.
1.
Log in to the XSCF shell.
2.
Execute the version command to determine the firmware version information.
In the following example, "-c xcp" is entered to determine the overall XCP version.
4.1.3 Confirming the FRU information and resource
information
Use XSCF shell commands to check the FRU information and resource information.
Table 4-2 lists the commands used for checking the FRU information and resource
information. For details on each command, see the Fujitsu M10/SPARC M10 Systems
XSCF Reference Manual of the XCP firmware version used.
Chapter 4 Preparation and Precautions for Maintenance 39