Fujitsu M10-4 - Restoring the Logical Domain to the Pre-Maintenance State

unknown
c2::dsk/c2t50000394281B50C6d0

disk

connected

configured

unknown
c2::es/ses0

ESI

connected

configured

unknown
c2::smp/expd0

smp

connected

configured

unknown
c3

scsi-sas

connected

unconfigured

unknown
c4

scsi-sas

connected

unconfigured

unknown
c5

fc

connected

unconfigured

unknown
c6

fc

connected

unconfigured

unknown
c7

scsi-sas

connected

unconfigured

unknown
＜
Omitted
＞
#

cfgadm

-c

configure

<Ap_Id>
#

svcadm

disable

hotplug
3.
If the system does not recognize the incorporated internal disk, make it
recognized in the system.
a. Execute the cfgadm -c configure command to incorporate the target internal
disk into the logical domain.
b. With the cfgadm -al command, check the status of the internal disk.
4.
If you have enabled the
hotplug service, execute the svcadm command to
disable the hotplug service.
5. Assign the I/O device of the incorporated internal disk to the logical domain.
- If you have replaced a faulty internal disk, proceed to "6.5.3 Restoring the
logical domain to the pre-maintenance state."
- If you have added a new
internal disk, perform operations according to the
description in "3.2.15 Configuring an I/O device" in Fujitsu M10/SPARC M10
Systems Domain Configuration Guide.
6.5.3 Restoring the logical domain to the pre-
maintenance state
This section describes the flow of work in restoring a logical domain after FRU
maintenance to the pre-maintenance state. For details on the work and the
commands used, see "3.2 Operations and Commands Related to Logical Domain
Configurations" in the Fujitsu M10/SPARC M10 Systems Domain Configuration Guide
and Oracle VM Server
for SPARC 3.1 Reference Manual.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 2014102