Fujitsu M10-4 - Removing the Power Cord

A
3.
Lower the cable support.
Figure 5-9
Handling the cable support
5.9.4 Removing the power cord
To perform work in cold maintenance, remove the power cord of the SPARC
M10-4/M10-4S. Remove the cable clamp from each power cord, and then remove the
power cords.
1.
Release the latch (A in the figure) of the cable clamp.
Figure 5-10
Removing the cable clamp
2.
Remove the power cord from the
PSU backplane unit.
Chapter 5 Preparations Required for Maintenance 85