Fujitsu M10-4 - Confirming the Software and Firmware Configurations

Table 4-1
Commands for checking the software configuration
Command Description
pkg(1) (Oracle Solaris 11)
showrev(1M) (Oracle Solaris 10)
Displays Oracle Solaris correction information
and version.
ldm(1M)
Displays logical domain configuration information.
#

pkg

info

entire

Name:

entire

Summary:

entire

incorporation

including

Support

Repository

Update

(Oracle

Solaris

11.1.12.5.0
).

*

SRU

version
#

showrev

-p
■
Number of mounted FRUs
■
Status of the unit in which a physical partition error or degradation occurred
■
Information on the PCI expansion unit
■
Name properties of the PCI Express (PCIe) card
4.1.2 Confirming the software and firmware
configurations
The software and firmware configurations and versions affect the operation of the
system. To change the configuration or investigate a problem, check the latest state
and check for any problems in the software.
Confirming the software configuration
Use Oracle Solaris commands to check the software configuration.
If you are logged in to the XSCF console, switch to the control domain console by
executing the console command beforehand.
Table 4-1 lists the commands used for checking the software configuration.
1.
Log in to the control domain console of the physical partition
where the FRU
requiring maintenance is mounted.
For details on logging in to the control domain console, see "8.3 Switching to
the Control Domain Console from the XSCF Shell" in the Fujitsu M10/SPARC
M10 Systems System Operation and Administration Guide.
2.
Execute the pkg(1) command to display Oracle Solaris correction information
and version.
- For Oracle Solaris 11, execute the pkg(1) command.
- For Oracle Solaris 10, execute the showrev(1M) command.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 201438