Fujitsu M10-4 - Chapter 3 Type Of Maintenance; Types of Maintenance Supported in the SPARC M10-4;M10-4 S

Table 3-1
Term definitions
Term Definition
Physical partition requiring
maintenance
Physical partition to which the SPARC M10-4 or SPARC
M10-4S containing the mounted Field Replaceable Unit
(FRU) requiring maintenance belongs
Chassis requiring maintenance Chassis of the SPARC M10-1 or SPARC M10-4S containing
the mounted Field Replaceable Unit (FRU) requiring
maintenance
Chapter 3
Type of Maintenance
This chapter describes the types of maintenance performed on the SPARC M10-4 and
SPARC M10-4S.
■
Types of Maintenance Supported in the SPARC M10-4/M10-4S
■
Active Maintenance
■
Inactive Maintenance
■
System-stopped Maintenance
Note that the terms used in this manual are defined as follows.
3.1 Types of Maintenance Supported in
the SPARC M10-4/M10-4S
The types of maintenance supported in the SPARC M10-4 and SPARC M10-4S
depend on the system operation status during maintenance. The supported
maintenance is divided into three types: active maintenance, inactive maintenance,
and system-stopped maintenance.
■
Active Maintenance
Maintenance is performed when the physical partition of an FRU requiring
maintenance is operating.
33