Fujitsu M10-4 - FRU Installation Workflow; Active Addition

Note -
When installing the SPARC M10-4S chassis for a SPARC M10-4S with a building block
configuration or single-chassis configuration, see "Chapter 9 Installing a System with a
Building Block Configuration" in the Fujitsu M10/SPARC M10 Systems Installation Guide.
7.3 FRU Installation Workflow
This section describes the installation workflow for the following FRUs of the
SPARC M10-4/M10-4S:
- CPU memory unit upper
- PCI Express card
- Memory
- Internal disk
- SPARC M10-4S chassis (Note)
7.3.1 Active addition
This section describes the workflows for active/hot and active/cold FRU installation.
References to detailed descriptions are written in the workflow. See any of them as
required. You can perform active/cold addition only for a system with a building
block configuration.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 2014138