Fujitsu M10-4 - Installing the CPU Memory Unit in the Chassis

Note -
If the CPU memory unit is inserted into the chassis as far as it will go, it may not be
possible to lift the lever. Lift the lever just before the CPU memory unit lower hits the rear
and then push it fully home.
Note -
Reinstall the PCIe card cassettes in their original positions by referring to the notes
that you made prior to the start of maintenance.
Note -
Reinstall the cables in the correct positions by referring to the notes you made before
starting maintenance.
9.8.2 Installing the CPU memory unit in the chassis
1.
With a hold on the Handling Position on both sides of the CPU memory unit,
insert the CPU memory unit into the chassis.
2.
Raise the right and left levers of the CPU memory unit to secure it.
3.
If a cros sbar unit was mounted, instal l the mounting frame and then tighten
the three screws.
4.
If any crossbar units were mounted, reinstall all of them.
For details, see "15.3 Installing a Crossbar Unit."
5.
Insta ll all the PCIe card cassettes.
For details, see "8.4.3 Installing a PCI Express card cassette."
6.
Lift the cable support to fix it.
For details, see "6.1.2 Fixing the
cable support."
7.
Connect the crossbar cables to the cable support.
For details, see "6.1.4 Attaching the crossbar cables to the cable support."
8.
Connect all the cables of the external interface.
The cables to be connected are as follows.
■
Interface cable connected to the PCIe card
■
Crossbar cables (If equipment rack model 26xx or equipment rack model 16xx
is used, connect them in step 6.)
■
XSCF BB control cable
■
XSCF DUAL control cable
■
XSCF-LAN cable
■
Serial cable
■
LAN cable
■
SAS cable
■
USB cable
Chapter 9 Maintaining the CPU Memory Unit/Memory 251