Fujitsu M10-4 - Incorporation of the Power Supply Unit and Fan Unit of the; Sparc M10-4;M10-4 S

270.....300.....330.....360.....390.....420.....450.....480.....510.....-
540.end
Initial

diagnosis

has

completed.
PSB

power

off

sequence

started.

[1200sec]

0.....

30.....end
PSB

powered

off.
PSB

Test

Fault
----

-------

--------
00-0

Passed

Normal
done
------------------------------------------------------------------------------
Maintenance/Replacement

Menu
Status

of

the

replaced

FRU.
FRU

Status

-------------------

--------------
/BB#0

Normal

------------------------------------------------------------------------------
The

replacement

of

BB#0

has

completed

normally.[f:finish]

:
f
------------------------------------------------------------------------------
Maintenance/Replacement

Menu
Please

select

the

chassis

including

replaced

FRU.
No.

FRU

Status
---

-------------------

--------------
1

/BB#0

Normal
2

/BB#1

Normal
3

/BB#2

Normal
4

/BB#3

Normal
------------------------------------------------------------------------------
Select

[1-4|c:cancel]

:
c
4.
Confirm that the statu s is normal ("Normal") after the replacement, and then
enter "f".
5.
When the maintenance menu appears, enter "c" to exit the operation.
6.2.2 Incorporation of the power supply unit and fan unit
of the SPARC M10-4/M10-4S
This section describes the procedure for incorporating an FRU into the system after
maintenance.
After replacing the FRU in step 7 in "5.8.2 Releasing of the power supply unit and
fan unit of the SPARC M10-4/M10-4S," continue here.
1.
After completing maintenance of the target FRU, return to the replacefru
command
operation of the XSCF firmware, and enter "f".
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 201494