Fujitsu M10-4 - Ping(1 M) Command

Table C-4
netstat(1M) command options
Option Description Application
-i Displays the interface status. The
displayed content includes
information on incoming and
outgoing packets, incoming and
outgoing errors, collisions, and
queues.
Allows you to view a concise
overview of the network status.
-i interval Specifying a numeric value after the
-i option executes the netstat(1M)
command at intervals of the
specified number of
seconds.
Identifies intermittent or long-term
network events. You can view
nighttime events at a glance by
piping the netstat output to a file.
-p Displays the media table. Allows you to check the MAC
addresses of the host on the
subnetwork.
-r Displays the routing table. Allows you to check the routing
information.
-n Converts a host
name into an IP
address and then displays it.
Allows you to check the IP address
instead of the host name.
#

netstat

-p
Net

to

Media

Table:

IPv4
Device

IP

Address

Mask

Flags

Phys

Addr
------

--------------------

---------------

--------

---------------
net0

4S-111-D0

255.255.255.255

SPLA

b0:99:28:98:30:36
net0

10.24.187.1

255.255.255.255

00:0a:b8:50:cd:42
net0

224.0.0.22

255.255.255.255

S

01:00:5e:00:00:16
Net

to

Media

Table:

IPv6

If

Physical

Address

Type

State

Destination/Mask
-----

-----------------

-------

------------

---------------------------
net0

33:33:00:00:00:01

other

REACHABLE

ff02::1
net0

33:33:00:00:00:02

other

REACHABLE

ff02::2
net0

33:33:00:01:00:02

other

REACHABLE

ff02::1:2
net0

33:33:00:00:00:16

other

REACHABLE

ff02::16
net0

b0:99:28:98:30:36

local

REACHABLE

fe80::b299:28ff:fe98:3036
net0

33:33:ff:98:30:36

other

REACHABLE

ff02::1:ff98:3036
#
The following example shows the netstat(1M) command output.
C.5 ping(1M) Command
The ping(1M) command sends the ICMP ECHO_REQUEST packet to network hosts.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 2014318