Fujitsu M10-4 - Releasing a SPARC M10-4;M10-4 S FRU from the System with the; Replacefru Command; Releasing of the SPARC M10-4 S Chassis; System with a Building Block Configuration)

XSCF>

dumpconfig

-v

-V

file:///media/usb_msd/ system.cfg
XSCF>

replacefru
------------------------------------------------------------------------------
Maintenance/Replacement

Menu
Please

select

the

chassis

including

replaced

FRU.
No.

FRU

Status
■
Network configuration information, advanced setting information, guest domain
configuration information, etc.
■
CPU Activation key, CPU Activation assignment, etc.
■
PPAR operation mode, time zone setting, user information, etc.
The following example shows the command for saving the XSCF setting information
on the USB device. For details, see "10.10 Saving/Restoring XSCF Setting Information"
in the Fujitsu M10/SPARC M10 Systems System Operation and Administration Guide.
5.8 Releasing a SPARC M10-4/M10-4S
FRU from the System with the
replacefru Command
The FRUs subject to the operation described here are as follows:
■
Releasing of the SPARC M10-4S chassis (possible only in a system with a building
block configuration)
■
Releasing of the power supply unit and fan unit of the SPARC M10-4/M10-4S
5.8.1 Releasing of the SPARC M10-4S chassis (possible
only in a system with a building block configuration)
In the following execution example, maintenance is performed on an abnormal
(Degraded) BB#0 chassis with four SPARC M10-4S units in a building block
configuration.
1.
Log in to the XSCF shell.
2.
Execute the replacefru command to display the maintenance menu.
3.
Select the FRU requiring maintenance by specifying it with a numeric key.
Since BB#0 is "Degraded," "1" is entered.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 201476