Fujitsu M10-4 - Installing the PSU Backplane Unit

3.
Tighten the screws on the oper ation panel to secure it to the PSU backplane
unit.
13.5.2 Installing the PSU backplane unit
This section describes the procedure for installing the PSU backplane unit.
1.
Insert the PSU backplane unit into the chassis by hold ing the handle.
2.
Tighten the two screws on the PSU backplane unit to secure it to the chassis.
3.
Reinstall the fan shelf and then tighten the two screws in the fan
slot.
Chapter 13 Maintaining the PSU Backplane Unit/Operation Panel 275